Accessing an LD4 Signal Status using L-band Control

Accessing the LD4 L-band is done using the L-Band control 2 software.

Latest versions are available online from VOSS at http://help.veripos.com or by clicking the following link VERIPOS L-Band Control 2.

• If required power up the LD4 unit  and connect to the L-band antenna.
• With the L-Band Control 2 software installed on the PC with serial ports available, connect the DB9 “LBAND Com1” connector to an available RS-232 serial port on the PC.
• Execute the L-Band Control 2 software - select the “Veripos L- Band Control 2” shortcut (Programs\Veripos folder in the “Start” menu).
• The software will search for the correct serial port and when found communicate with the LD4.

When the connection is established, the screen will be similar to the one below:

This page displays the unit type and baud rate used. Click OK then the main menu screen will be displayed: 

Select Signal and Status Information and this will display additional data on the status of the demodulator.