As the Standard+ service is being stopped, users are recommended to remove the Standard+ calculation from their LD2 / LD2S configurations. Users who were previously enabled for Standard+ as their highest service should enable their VERIPOS unit(s) for the VERIPOS Ultra Service.
Users only enabled for the VERIPOS Standard or Standard2 service do not need to disable Standard+ Service, However all other users should complete the following actions to remove Standard+ from their fall back solutions.
Remove Standard+ Calculation
This procedure stops the Standard+ corrections from being input into the VERIPOS algorithms within the LD2 / LD2S unit. As a result the Standard+ calculation will not initialise or be used.
From any point in the menu structure repeatedly press *Page* until the Main menu Configuration screen is displayed:
Press *Enter* then press the *Page* key three or four times (depending if Beacon or HF/MF receiver is installed) to display:
Press *Enter* to display:
If “Use STD Plus? Y” is displayed press *Toggle* then press the * Enter * to change it to “Use STD Plus? N”:
Reboot the LD2 by cycling the power to the unit using the power switch on the rear panel.