It is recommended to stick to one of the two PPP solutions.
However, users can change between them without interrupting the Tides calculations.
To change, select Config > Calculation > MSS Tides... and change the Position option:
Articles in this section
- I have just changed beams and my station list is not fully populated why is this?
- How to load a Verify QC Config onto the LD6 in QC mode?
- What are the new features of Verify-QC v1.20?
- How do I upgrade my verify QC?
- How do I configure an N-Trip RTCM input in Verify QC?
- Tides - How do I convert from MSS Tides to LAT?
- Tides-When will tides reset?
- Tides-If I restart QC does Tides restart?
- How do I configure Verify QC to compute an Apex (Apex2) solution
- I have rebooted my LD2, connected to Verify QC using the Ethernet Port and GNSS Rx in Calculation Status has turned red and stayed red. How do I get it green again?
Comments
0 comments
Please sign in to leave a comment.