Press Home button in front of LD5 unit then navigate to and select GNSS in home screen of LD5:
Then select Config followed by NMEAa or NMEAb as shown below:
Select the NMEA messages you want to output by selecting the desired message and switching the status to On. Use left and Right button to go to next page and Apply to accept the changes:
Select Home on front of LD5 unit then navigate to and select Config to choose output NMEA:
Select IO and choose which comport you want to output (COM1, COM2 or COM3). On rear of LD5 you can see the comport mappings and make sure you select a free comport which is not in use.
Once the comport is selected press the Tick button to expose the list of available data steams, select GNSS NMEAa or GNSS NMEAb depending which option you selected in the earlier step and select Next:
Choose desired Protocol, Baud, Data Bits, Parity and Stop Bits as necessary. Use the left and Right buttons to switch between pages and Apply to accept the changes or select Back to cancel changes:
Connect LD5 and PC through serial cable and launch Hyper Terminal from start menu as shown below.
Note: In the below example Hyper Terminal is used to log the data, other terminal applications can be used:
Once you have opened Hyper Terminal Enter file name and choose available comport in PC which you want connect from LD5:
Enter the Baud Rate, Data Bits, Parity and Stop Bits to match the LD5 Settings.
Once data is showing in the Hyper Terminal window, click Transfer and Capture Text to log data:
Click the Browse button, choose the Path where you want to save NMEA data and enter a File name and click Save:
Click Start to commence logging.