Legacy Products
VERIPOS Legacy FAQ's, Technical Documentation and Software.
LD2 - LD2S Equipment
- Configuring a Verify DP Heading input through USB
- Configuring a Verify DP Heading input on PORT3
- LD2 DP Bridge Card
- How do I check version number of my LD2?
- How do I configure my LD2 to use the Apex service?
- LD2 Quick Guide
LD4 Equipment (EoL)
- Accessing an LD4 Signal Status using L-band Control
- How do I change the PPP Calculation of the LD4?
- I have just changed beams and my station list is not fully populated why is this?
- I have just changed beams and my station list is not fully populated why is this?
- What is the PPS voltage of my LD4?
- I have changed my PPP service and my LD4 solution has become unstable, how do I resolve this?
Verify-DPx Software
LD3 - LD3S Equipment
- How do I configure my LD3S-GG2 to use the Apex service?
- LD3 Installation Manual
- LD3 Operations Manual
- I have just changed beams and my station list is not fully populated why is this?
- I have changed my PPP service and my LD3S solution has become unstable, how do I resolve this?
- How do I enable/disable my LD3/LD3S?
Verify-DP Software
LD7 Equipment
- How do I check the GNSS receiver firmware version on my LD7?
- How do I configure my LD7 to use the Apex service?
- LD7 USB Drivers
- LD7 Installation Manual
- LD7 Operations Manual
- LD7 Quick Guide
Verify-QC Software
- How to Import Verify QC Config Files from a USB to an LD6
- Why is one section of the RINEX logging menu of Verify QC greyed out?
- How do I check the version number of my Verify QC software?
- How do I setup Apex as backup within Verify QC?
- Verify-QC v1.20 User Manual
- Verify-QC for LD6 Version User Manual