Logo
Submit a request
Sign in
  1. VERIPOS
  2. FAQ's
  3. LD6 Equipment

LD6 Equipment

Follow New articles New articles and comments
  • Setting up LD6 Outputs for VQC
  • Configuring an LD6 TRINAV Output
  • How to configure NMEA sentences on LD6 versions 101 and 105
  • How to Configure NMEA Sentences on an LD6 version 8 or 50
  • How do I check the IP address of my LD6?
  • How Do I Change a Beam on an LD6?
  • How do I enable and output a heading from an LD6?
  • What Version of GNSS Card is Installed on my LD6?
  • What files should I send for data analysis from a LD6 while running quantum on board?
  • What direction is the heading on my LD6?
  • How do I manually enter an L-band frequency on the LD6?
  • How do I configure my LD6 to use the Apex service?
  • How do I configure an LD6 to receive RTK corrections?
  • How do I tell which version of LD6 I have?
  • How do I correctly shut down a LD6?
  • I have just changed beams and my station list is not fully populated- Why is this?
  • What is the expected latency from one PPS to the NMEA ZDA telegram on the LD6?
  • What are the serial pin-outs of the LD6?
  • How do I remove satellites from my LD6 version 8 or 50?
  • What is the PPS voltage and pulse width of my LD6?
  • How do you load a Verify QC Config onto the LD6 while in QC mode?
  • How do I enable SBAS on my LD6 IMU?
  • What are the tracking capabilities of my LD6 and what services are available to my unit?
  • How do I check the GNSS tracking capabilities of my LD6 version 8 or 50?
  • How do I factory reset my LD6 unit?
  • How do I archive data on an LD6?
  • How do I implement a basic LAN interface between an LD6 and my Verify QC computer? (v1.11 or later)
  • What is the best way to interface Verify QC to my LD6 units?
  • How do I interface my antennas to the LD6?
  • How do I change the PPP solution when my LD6 is enabled for both Apex and Ultra services?
  • 1
  • 2
  • ›
  • »
VERIPOS Cookie Settings Privacy Policy